3.3.4. Analysis. Analysis information shall contain the following:
a. Statement identifying the parts, subassembly, assembly of equipment being
analyzed.
b. Verification that a worse cast tolerance analysis allows no excessive
interferences, clearances, or excursions to exist that would cause failure.
c. Verification that the part, subassembly, assembly or equipment performs properly under all applicable environmental conditions.
d. A tolerance distribution for economical processing of the part, subassembly,
assembly or equipment.
e. Applicable areas of engineering drawings or sketches to assist in the
understanding of the analysis
f. All calculations relevant to the analysis
g. Any problems of potential problems with the part, subassembly, assembly
or equipment.
Defines standard
Replaced/Superseded by document(s)
Cancelled by
Amended by
| File | MIME type | Size (KB) | Language | Download | |
|---|---|---|---|---|---|
| Report of Dimensions and Tolerances.pdf | application/pdf | 21.66 KB | English | DOWNLOAD! |
Provides definitions
Cover images
Introduction
This report documents a mechanical worst case tolerance analysis performed on parts,
subassemblies, assemblies and equipment.
This Data Item Description (DID) contains the format and content preparation instructions for the data product generated by the specific and discrete task equipment for this data included in the contract.